Clarion Platinum Sound Processor Betriebsanweisung PDF herunterladen (Seite 29)

Cochlear Baha® Divino / Baha® Intenso /

Baha® Compact

List of required parts

Cochlear Baha®

sound processor

MLxi Baha

Fitting with the user

1. Plug the MLxi Baha into the Baha sound processor. Make

sure that the white circled pin of MLxi Baha lines up to

the red circle On the hearing instrument.

2. Switch On the Baha sound processor and FM transmitter.

3. For optimum dynamic FM benefit, turn the AGCO

potentiometer on the Baha sound processor as high as

it is tolerable for the patient.

4. Test the patient’s speech recognition in quiet at normal

sensitivity with the Baha alone and then through the

wireless FM system only (out of range of the processor

microphone). Performance should be similar between

these two conditions. If the FM is too loud or too soft, the

FM programming software from Phonak may be required

to optimize the FM volume level.

Additional information

Enabling the push button will have following effects:

a. Long press: switch MLxi Baha On or Off respectively

b. Short press: switch between FM+M and FM only in case

a non Dynamic FM transmitter is being used.

Listening check

Use the MLxi Baha adaptor to connect the MLxi Baha to 

the headset checker (see page 12). Turn On the headset

checker and FM transmitter and you should hear the FM

signal.

Use the MLxi Baha adaptor to connect the MLxi Baha to 

an audioshoe attached to a hearing instrument. Turn On

the hearing instrument and switch it to the FM program

if required.

MLxi Baha

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Keine Kommentare

Clarion Platinum Sound Processor Betriebsanweisung Seite 29