Clarion Platinum Sound Processor Betriebsanweisung PDF herunterladen (Seite 23)

MED-EL OPUS2

List of required parts

OPUS2 speech processor

FM Battery Pack Cover

MLxi or MicroMLxS

Fitting with the user

1. Turn all equipment Off.

2. Replace the standard battery cover by the FM Battery Pack

Cover.

3. Plug the FM receiver into the bottom of the FM Battery

Pack Cover. The MicroMLxS is usually used in the two green

dot position.

4. Switch the speech processor and FM transmitter On.

5. Test the patient’s speech recognition in quiet with the

CI alone and then through the wireless FM system only

(out of range of the processor microphone). Performance

should be similar between these two conditions. If the

FM is too loud or too soft, the FM programming software

from Phonak may be required to optimize the FM volume

level.

6. Evaluate FM benefit as well as the appropriateness of FM

settings trough speech-recognition assessment in the

clinic and standardized questionnaires completed by the

recipient, family members and teachers.

Additional information

When MicroMLxS is used, the switch acts as following:

a. Two green dots: FM + M

b. One green dot: FM only (processor microphones

attenuated)

When MLxi is used and the push button is enabled, the push

button acts as following:

a. Long press: switch MLxi On or Off respectively

b. Short press: switch between FM + M and FM only in case

a non Dynamic FM transmitter is being used.

Listening check

Plug the MLxi or MicroMLxS into the headset checker (See 

page 12). Turn On the headset checker and FM transmit-

ter and you should hear the FM signal.

Plug the MLxi or MicroMLxS into an audioshoe attached 

to a hearing instrument. Turn On the hearing instrument

and switch it to the FM program if required.

3 2 1

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Keine Kommentare

Clarion Platinum Sound Processor Betriebsanweisung Seite 23