Clarion M10 Series Bedienungsanleitung PDF herunterladen (Seite 21)

C-SPEC CORPORATION WIRELESS PRODUCTS

CLARION MerLAN M10 19

UPGRADE PROCEDURE

The upgrade procedure requires that the MerLAN M10 unit be connected

directly to the NIC on the PC via an AUI cable, or 10BaseT cable with an AUI

to 10BaseT media converter which crosses the send and receive data signals,

or thru a hub. Perform the following steps to upgrade the MerLAN M10.

1. Connect the Clarion Power Supply to the M10. Wait for the blinking of

the red TX LED to stop before trying to run the upgrade program.

2. Type UPGRADE <xxxxxx> where <xxxxxx> is the last six digits of the

serial number of the M10 unit which is written on the label attached to

the bottom of the unit or is the Clarion NULL address of six zeroes. The

first six digits are always 00606F. If the unit is configured to use the

Clarion NULL address, then type UPGRADE 000000 . If the unit is not

configured to use the NULL address and if the serial number is

00606F040417, then type UPGRADE 040147. You will see the following

messages displayed:

**********************

* M10 Uploader v2.7

**********************

Initializing IPX...

Canceling pending events...

Getting network address...

Setting target address...

Getting local node...

Uploading...

Frame: 24/24, 024840 bytes...

NOTE: The frame number begins at 01/24 and increases up to 24/24 during

which the red TX LED begins blinking twice at approximately 2 second

intervals. The completion of the firmware transmission is indicated by the

red TX LED remaining on and the following messages being displayed.

Transfer complete

Wait for boot LED or AUI boot message (apox. 4 mins)

Hit any key to exit.

04:17

At this time, the MerLAN M10 starts burning the EEPROM and the red TX

LED remains on and blinks approximately every 20 seconds. The AUI cable

may be disconnected at this time to be used to connect another M10 for

upgrade purposes but the power cable must remain connected throughout the

burning process which takes approximately 4.5 minutes after which the red

TX LED goes off.

1 2 ... 16 17 18 19 20 21

Keine Kommentare

Clarion M10 Series Bedienungsanleitung Seite 21