Clarion M10 Series Bedienungsanleitung PDF herunterladen (Seite 20)

C-SPEC CORPORATION WIRELESS PRODUCTS

to perform the upgrade. The upgrade software uses Novell’s IPX/SPX

protocol and will run under DOS or as a DOS program under Windows 3.1.

Of course, the PC must have a network interface card (NIC) installed with an

AUI and/or a 10BaseT port. If the NIC does not have an AUI port, then a

10BaseT to AUI converter must be used, such as a hub with both types of

connections or an AUI to 10BaseT media converter. If the MerLAN M10 is to

be directly attached to the NIC with an AUI port, then an AUI transceiver

cable can be used to make the connection. If the MerLAN M10 is to be

directly attached to the NIC with a 10BaseT port, then an AUI to 10BaseT

media converter must be used which can crossover the send and receive

signals. There is no problem if a hub is used as the media converter. Finally,

the standard Clarion Power Supply accessory for the MerLAN M10 must also

be used to power the unit.

INSTALLATION

The following steps should be taken to install the upgrade software:

1. Prepare your PC to execute a DOS program.

2. Insert the floppy disc labelled “M10 UPGRADE” into a floppy disc drive.

3. Type A: or B: to change to the floppy disc drive where the disc was

inserted.

4. Type INSTALL <drive> where <drive> is a letter of a hard disc drive of

the PC (usually C:). The install procedure automatically creates a new

directory called M10UG on the selected hard drive and extracts the

upgrade programs and files into it.

1 2 ... 15 16 17 18 19 20 21

Keine Kommentare

Clarion M10 Series Bedienungsanleitung Seite 20