OWNER'S
MANUAL
INSTALLATION
This sectIOn lists Mounting and Winng PrecautIOns for Installing the Clanon
APX400.4. Combined with the expenence
of
a professIOnal Installer, these
safeguards provide enough detail to successfully complete an installatIOn.
If
you do not have the necessary skills, do not Install the amplifier yourself.
Instead, see your authonzed Clanon dealer for installation recommendatIOns.
MOUNTING
PRECAUTIONS
Although the Clanon APX400.4 Incorporates heat sinks and protectIOn cIrcUIts,
mounting the amplifier
In
a tight space without any air movement can still
damage Internal circUitry over time. Choose a site that provides adequate
ventilatIOn around the amplifier. For easy system set-up, mount the amplifier
so the front panel controls will be accessible after installatIOn.
In additIOn, observe the following precautIOns:
1.
For the most effiCient cooling, mount the amplifier so cool air runs along the
length
of
the fins rather than across them. Remember, any moving air will
diSSipate heat.
2. Mount the amplifier on a
ngld
surface.
AVOId
mounting to subwoofer
enclosures or areas prone to vibratIOn. Do not Install the amplifier on plastic or
other combustible matenals.
3.
Pnor
to drilling, make sure proposed mounting holes will not cut Into the
fuel tank, fuel lines, brake lines (under
chaSSIS),
or
electncal wmng.
WIRING
PRECAUTIONS
Read all
wmng
precautIOns.
If
you are not sure
of
the connectIOns, contact
your authonzed Clanon dealer.
1.
Before installatIOn, make sure the source umt Power sWitch
IS
In
the OFF
posItion.
2.
Disconnect the negative (-) lead
of
the battery before making any power
connectIOns.
3.
When making connectIOns, be sure that each connectIOn
IS
clean and secure.
Insulate final connectIOns with electncal tape
or
shnnk
tubing. Failure to do so
may damage your eqUipment.
4. A secure clean ground connectIOn
IS
cntlcal to the performance
of
your
Clanon amplifier. Use the shortest ground wire possible snd securely connect
to the car
chaSSIS
to minimize resistance and
aVOid
nOise
problems.
5.
Add an external fuse on the amplifier's positive (+) power lead and connect
It
as close as possible to the vehicle's (+) battery terminal. Use a rating that
equals the total current consumptIOn at full output
of
all amplifiers
In
the
system. Adding an external fuse will protect the electncal system from short
CirCUits
that can cause a fire.
11
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern