Clarion GRAND CHEROKEE PSWJPGC Bedienungsanleitung PDF herunterladen

Preassembled

(1) Roto-molded subwoofer enclosure

(2) 8"; 2 ohm subwoofer

(1) 100W class "D" amplifier

(2) Speaker grille

Loose Components

(1) 17’ wire harness w/ pigtail style connector

(4) 1" self-taping Phillips screws

(1) 1/2" ground screw

(1) Star washer

(2) Attachment Hold Down Clamps

(2) “U” shaped brackets

PREPARATION

Parts list

(Qty) Component

Note: Installer MUST disconnect speaker-input leads to amplifier when using line-level input

WIRING:

OVERVIEW

The Clarion Camouflage subwoofer system provides for the installation of a low frequency driver in an enclosure which

is powered by a small low current, high power class "D" (Digital) amplifier. The advantage to using this type of amplifier

is in the low current consumption of the amplifier at high power levels. The class "D" amplifier provided with this system

will produce a rated 100W into a 2 ohm load. The woofer supplied with this system uses a voice coil with rated imped-

ance of 2 ohms, and therefore is not considered a standard woofer. Replacing the woofer with any driver having an

impedance greater than 2 ohms will yield lower power output from the amplifier, and is not recommended.

PROCEDURE

Proper installation of this product requires proper tools and knowledge of car audio principles. If you are not comfortable

performing any of the outlined tasks below, contact a professional installation facility to perform the work.

OUTLINE

• Remove the head unit.

• Connect the Clarion "T" harness between the radio and factory wiring and route the harness extension to rear pas-

senger side of the vehicle.

• Remove rear quarter trim panel.

• Install subwoofer enclosure.

• Test subwoofer enclosure and head unit functions (fade, balance, dim, etc.).

• Adjust subwoofer gain.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CON-

DITIONS.

(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND

(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDE-

SIRED OPERATION.

1 2 3 4

Inhaltsverzeichnis

Seite 1 - PROCEDURE

1Preassembled(1) Roto-molded subwoofer enclosure (2) 8"; 2 ohm subwoofer(1) 100W class "D" amplifier(2) Speaker grilleLoose Components

Seite 2

2Ia. WIRING USING A CLARION “T” HARNESS• STEP 1: Remove the Radio.• STEP 2: Connect the "T" Harness.A. Unplug factory wires from radio.B.

Seite 3 - IV. ATTACH THE ENCLOSURE

3II. RUN WIRE HARNESSA. Run harness to the rear driver’s side wheel well hump.III. TEST THE ENCLOSUREA. Remove security shade from the rear cargo area

Seite 4 - V. REASSEMBLE THE VEHICLE

4V. REASSEMBLE THE VEHICLEA. Make sure all the wires are hidden. Then do the process inreverse order.Clarion Corporation of America 661 West Redondo B

Kommentare zu diesen Handbüchern

Keine Kommentare

Clarion GRAND CHEROKEE PSWJPGC Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Mikrofone Clarion GRAND CHEROKEE PSWJPGC herunter. Clarion GRAND CHEROKEE PSWJPGC User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrofone Clarion GRAND CHEROKEE PSWJPGC